How to drip acclimate new fish and coral

A careful drip-acclimation process for new fish and corals, plus Seachem’s published Reef Dip directions for a separate-container coral dip.

New fish and corals often arrive in water that does not match your tank’s temperature or salinity. Moving them straight in can shock them. Drip acclimation means adding your tank water to their bag or a container slowly, so they adjust before they go in. This guide covers that process and, for corals, Seachem’s published Reef Dip directions. It is not a substitute for a quarantine tank if you use one, and it does not replace a finished cycle — see Cycling a new tank before adding animals to a new setup.

Quick answer: drip rate and how long

A widely used published guideline, from LiveAquaria’s step-by-step acclimation guide:

Float the sealed bag About 15 minutes, lights dimmed, to match temperature
Drip rate About 2–4 drips per second
How long Volume doubles about every ½ hour; discard half, then let it double once more (about 1 hour total)
Upper limit Never more than 2 hours total
Don’t Add an airstone to the shipping water, or pour shipping water into your tank

Treat these as a starting point and watch the animal. The Simplicity Precision Drip Acclimation Kit has a control valve to set the drip and a priming hand pump, so there is no mouth siphoning. Corals then get a Seachem Reef Dip (directions below).

What you’ll need

Simplicity Precision Drip Acclimation Kit

Drip acclimation kit

Simplicity Precision Drip Acclimation Kit

tubing, a control valve, and a way to start the siphon

$12.95

Seachem Reef Dip
Seachem Reef Dip

for corals, anemones, and polyps, used in a separate container

From $6.08

Choose size
D-D Seawater Refractometer w/ Auto Temperature Compensation

Seawater refractometer

D-D Seawater Refractometer w/ Auto Temperature Compensation

so you know the tank’s salinity before you start

$69.99

Have the display tank’s temperature and, for saltwater, salinity already stable. Do not add animals to a tank that is still cycling or swinging day to day.

Before you open the bag

  1. Turn the room lights down and float the sealed bag in the tank just long enough for the water in the bag to approach tank temperature. Keep the bag closed while you do this so tank water and bag water do not mix yet.
  2. Open the bag into a clean container, or use the bag itself if it will stand safely. Keep livestock covered with water. Do not pour the shipping water into your display tank. That water can carry waste, medication, or pests.
  3. Start a slow siphon of tank water into the container with the drip kit. The Simplicity kit uses a valve so you can keep the drip gentle. Follow the instructions in the kit, and err on the side of slower rather than faster. There is no single official drip rate that fits every animal, so watch the livestock instead of watching the clock.Simplicity Precision Drip Acclimation KitDrip acclimation kitView product →
  4. Let the volume in the container rise gradually as tank water dilutes the shipping water. If the container gets full, discard some of the mixed water (not into the tank) and keep dripping. Stop if the animal is clearly in distress, and give it a few minutes before you continue.
  5. Move the animal, not the water. Lift fish with a Seachem fine-mesh net or coarse-mesh net, or a small container of the mixed water, then release them into the tank and discard the rest. For corals, go to the dip step below before they go into the display.

Freshwater fish follow the same temperature-then-water routine, without the salinity step. A water conditioner belongs in the tank’s new water, not as a shortcut to skip acclimation — see How to use Seachem Prime.

Dipping corals, from Seachem

After the coral has been acclimated, dip it in a separate container. Do not add Reef Dip to the aquarium. Seachem’s published directions:Seachem Reef Dip 100 mL bottleSeachem Reef DipView product →

  • Remove 4 L (1 US gallon) of water from the source aquarium into a container suitable for dipping.
  • Add 5–10 mL (1–2 capfuls) of Reef Dip and mix.
  • Place the coral in the dip for 15–30 minutes, depending on the severity of the problem. Seachem also supports using it prophylactically, before you introduce new corals, even when there is no obvious disease.
  • In very severe cases, Seachem says a double dose may be used. With clear, accessible lesions, the concentrate may be painted on the lesions directly before placing the coral in the dip.
  • Watch for adverse reactions such as excessive sliming, and remove the coral if that happens.

Seachem says Reef Dip is safe for stony and soft corals, and also for anemones and polyps. It is an elemental iodine complex with a protective slime-coat agent, and it is meant to disinfect against bacteria, fungus, and protozoans. A few limits from Seachem’s own FAQ:

  • Remove crabs or shrimp from a coral, such as an Acropora, before dipping. Seachem says not to use the dip with those animals still on the coral.
  • Reef Dip is intended for corals and anemones. Seachem does not recommend it for clams.
  • Seachem does not present it as a reliable way to eliminate hydroids from live rock or macroalgae.

After the dip, do not pour the dip water into the tank. Place the coral on a stable rock or frag plug, then discard the used dip water down the drain.

The first hours in the tank

  • Give new arrivals dimmer light and a little cover. Do not chase them to “show” them the tank.
  • Hold off on a heavy feeding until they are settled.
  • Keep testing the tank as usual. A new animal adds waste; that is normal, but a spike in ammonia is not. See Testing your water.
  • If you are building a first reef, the broader order of operations is in Setting up your first reef tank.

Orders ship in 1–2 business days, and shipping is free on orders of $35 or more. Most equipment is returnable for 365 days with free return shipping and no restocking fee. Opened chemicals, foods and medications are not returnable — that includes an opened bottle of Reef Dip.

If you want help choosing a drip kit or a bottle size, ask us through the contact form.

Shop maintenance & tools Saltwater