How to raise magnesium in a reef tank
Test magnesium first, then raise it gradually with a liquid or powder supplement under the maker's daily limit. Fix Mg before calcium and alkalinity.
Short answer: Test magnesium first with a reef magnesium kit. If it is low, raise it gradually with a magnesium supplement such as Fritz RPM Liquid Magnesium, Brightwell Magnesion, Seachem Aquavitro Ions or Tropic Marin Bio-Magnesium, staying under the maker's daily maximum and retesting between doses. Fix magnesium before you chase calcium and alkalinity. The figures below are the manufacturers' published directions; always follow the label on the bottle you own.
Why magnesium matters in a reef tank
Magnesium is the quiet partner of calcium and alkalinity. Salifert states that magnesium (1,300–1,400 mg/L in natural seawater) keeps calcium and alkalinity in balance by slowing the unwanted chemical precipitation of calcium carbonate. Fritz goes further: it says it is impossible to maintain calcium and alkalinity at the proper levels without also maintaining magnesium, and that if magnesium is too low, adding calcium and alkalinity supplements will simply result in calcium carbonate precipitating out.
ATI describes magnesium as essential for stony corals, coralline algae and soft corals, and says deficiencies result in brittle skeletons and poor polyp extension. If calcium or alkalinity will not stay up no matter how much you dose, that is the moment to test magnesium.
What you need
| Item | Why | Options we carry |
|---|---|---|
| Magnesium test kit | You cannot see magnesium. Test before every correction and again after | Salifert Magnesium Test Kit, Nyos Magnesium Test Kit |
| Magnesium supplement | Raises a low reading and maintains it | Fritz RPM Liquid Magnesium, Brightwell Magnesion, Aquavitro Ions, Tropic Marin Bio-Magnesium, ATI Elements Magnesium, ATI ICP Element Magnesium |
| Calcium and alkalinity tests | Magnesium, calcium and alkalinity should be read on the same day | See our test kits |
| Salinity check | Tropic Marin notes that specific gravity can creep up slightly over time when dosing magnesium, so check it regularly | How to use a refractometer |
Step 1: Test magnesium
Both kits we stock are titration tests made for saltwater:
- Salifert Magnesium Test Kit — reads in 30 mg/L steps, about 50 tests per kit, and Salifert states it does not suffer from calcium and strontium interference within normal bounds.
- Nyos Magnesium Test Kit — 50 tests, reads in 15 ppm (mg/L) increments, with a pink-to-blue endpoint and German-made reagents.
Write the number down, along with calcium and alkalinity. Test at about the same time of day each time so readings are comparable. For a full test routine, see which test kits you need.
Step 2: Pick your target
Makers do not all publish the same number. Choose the range that matches the product you dose and hold it steady:
| Source | Published magnesium range |
|---|---|
| Fritz RPM Liquid Magnesium | 1,300–1,400 ppm |
| Salifert Magnesium Test Kit | Natural seawater 1,300–1,400 mg/L |
| Brightwell Magnesion | 1,290–1,320 ppm, held within about ±10 ppm |
| Seachem Aquavitro Ions | 1,200–1,350 mg/L |
| Tropic Marin Bio-Magnesium | Natural seawater averages 1,280–1,300 mg/L; avoid going above 1,600 mg/L |
Step 3: Choose a magnesium supplement
| Product | Form | Maker's raise rate | Maker's daily limit |
|---|---|---|---|
| Fritz RPM Liquid Magnesium | Liquid, magnesium chloride + sulfate (70,000 ppm min.) | 1 mL raises 1 US gallon by 18 ppm (5 mL raises 10 gal by 9 ppm) | Correction rate 10 mL per 10 gal per day; with fish present, no more than 5 mL per gallon per day |
| Brightwell Magnesion | Liquid | 1 mL raises 1 US gallon by 26 ppm | 10 mL per 20 gal per day when below 1,288 ppm |
| Seachem Aquavitro Ions | Liquid, 90,000 mg/L, ammonia-free | 5 mL per 90 L (25 gal) raises about 5 mg/L | 25 mL per 90 L (25 gal) per day |
| Tropic Marin Bio-Magnesium | Powder | 1 measuring spoon raises about 10 mg/L per 100 L (26 gal) | 2 spoons per 100 L per day |
| ATI Elements Magnesium | Liquid | 10 mL per 100 L raises 10 mg/L | See label |
| ATI ICP Element Magnesium | Liquid, 100,000 mg magnesium per bottle | 1 mL per 100 L raises 1 mg/L | 100 mL per 100 L (26 gal) per day |
Liquids are the easiest to measure and to run on a dosing pump. Bio-Magnesium is a powder you stir in at the surface; Tropic Marin says to keep undissolved crystals off corals and add the next spoon only after the previous one has dissolved.
Step 4: Dose in stages and retest
- Work out the gap. Target minus your reading = how many ppm you need.
- Work out the total dose with the raise rate above. Brightwell's own example math: each mL of Magnesion raises 1 gallon by 26 ppm, so divide the rise you need by 26 and multiply by your water volume in gallons. Fritz and Tropic Marin publish online dose calculators.
- Split it across days so no single day goes over the maker's daily limit in the table above. Fritz, Brightwell and Aquavitro all describe dosing at their daily rate until the target is reached, then switching to maintenance.
- Add it as the label directs, and not at the same moment or spot as your alkalinity dose. Fritz, Brightwell and ATI all say to shake the bottle well before use.
- Retest magnesium, plus salinity, calcium and alkalinity, before the next dose.
Keep magnesium and alkalinity products apart. Seachem warns not to mix magnesium directly with any carbonate supplement and recommends dosing magnesium and carbonate on alternate days or at least 30 minutes apart (Aquavitro says Ions can be dosed within minutes of the rest of the Aquavitro line).
Step 5: Keep it steady
Once you are in range, switch from correcting to maintaining. Brightwell's method is to measure magnesium at the same time each day over one to two weeks, find the daily drop, and dose that amount daily; it says daily dosing keeps levels more stable than weekly. Aquavitro's beginner routine is 5 mL per 90 L twice a week, checking magnesium weekly. If you already run a two-part or all-in-one system, magnesium may already be covered: Tropic Marin All-For-Reef supplies calcium, carbonate hardness, magnesium and trace elements together. If you run Balling, see how to use Tropic Marin Original Balling. Tropic Marin's instruction is to bring calcium, alkalinity and magnesium to target first, then maintain.
FAQ
Why won't my calcium or alkalinity go up?
Test magnesium. Fritz states that low magnesium causes added calcium and alkalinity to precipitate as calcium carbonate. Correct magnesium first, then read our guides on raising calcium and raising alkalinity.
Can magnesium be too high?
Yes. Tropic Marin advises avoiding concentrations above 1,600 mg/L, as various organisms may react negatively. Seachem warns that excess magnesium may enhance the loss of carbonate alkalinity. If you overshoot, stop dosing and let consumption and water changes bring it back.
My magnesium is very low. Can I fix it in one day?
No. Every maker above sets a daily maximum, so a large gap takes several days. Aquavitro notes that a very large deficit takes a lot of any supplement and suggests looking at a salt mix with a more appropriate magnesium level; see which salt you should buy.
Do I need magnesium in a freshwater tank?
This guide is for reef and saltwater tanks. All the supplements and test kits above are sold for reef or marine aquariums.