How to get rid of flatworms in a reef tank

Remove red planaria flatworms safely: siphon first, prep carbon and a water change, then dose Flatworm eXit or Flatworm Rx by the label.

Short answer: to get rid of red planaria flatworms in a reef tank, siphon out as many as you can, have fresh activated carbon and a 25% water change ready, then dose a flatworm treatment such as Salifert Flatworm eXit or Blue Life Flatworm Rx exactly as the label says. Dying flatworms release toxins, so the carbon and water change matter as much as the treatment.

First, make sure they are flatworms

The common reef pest is the small rust-red or brown flatworm (often called red planaria) that gathers on sand, rock and the glass, usually where light is strongest. That is the type Flatworm eXit and Flatworm Rx are made for. Other pests look similar, so look closely before you treat:

  • Red planaria flatworms: flat, oval, rust-colored, sitting on surfaces in groups. Treat as below.
  • Acropora-eating flatworms: hard to see, live on Acropora colonies and leave bite marks. These are handled by dipping the affected corals and removing eggs, not by a whole-tank flatworm dose.
  • Bristleworms and other worms: round, segmented or long. These are usually harmless cleanup crew, so don't treat for them.

What you need before you treat

Item Why Pick
Flatworm treatment Kills the flatworms Salifert Flatworm eXit or Blue Life Flatworm Rx
Fresh activated carbon Pulls out toxins from dying worms Kolar Labs Granular Activated Carbon or Simplicity Ultra Carbon
Saltwater for a 25% water change Dilutes toxins after the treatment Your usual reef salt, mixed ahead of time
Filter sock Catches worms you blow off the rock Simplicity Mesh Filter Sock or Felt Filter Sock
Siphon or airline tubing Removes worms before and after dosing Any clean siphon

Running carbon in a reactor or canister gives the best contact. See how to use a media reactor, and our water change guide for the change itself.

Step 1: Remove as many as you can by hand

Both makers say to siphon out as many flatworms as possible before dosing. Fewer worms dying in the tank means fewer toxins. Blow them off rocks with a turkey baster so they land in the water column, catch them in a filter sock, and siphon clusters off the sand and glass. Doing this a few days in a row can make a big dent on its own.

Step 2: Treat with Salifert Flatworm eXit

Salifert's directions, as shown on our product page:

  1. Prepare fresh activated carbon in a canister or reactor with good flow, about 1 lb per 50 gallons. Remove the existing carbon and turn off UV and ozone. Keep the skimmer running.
  2. Add 1 drop per gallon (4 liters) in a high-flow area. A 10 ml bottle holds about 300 drops.
  3. If the flatworms show no reaction within 45 minutes, add 50% more.
  4. As soon as the flatworms start to react, run the fresh carbon and siphon out the worms.
  5. Watch the tank for at least 6 hours and have a 25% water change ready. UV and ozone can go back on after about an hour.

Or treat with Blue Life Flatworm Rx

Blue Life's directions, as shown on our product page:

  1. It ships as a powder. Fill the bottle about 98% full with RO water, snap on the dropper tip, cap it and shake until no powder is visible.
  2. Siphon out as many flatworms as you can.
  3. Add 4 drops per 10 US gallons, one drop at a time, in high-flow areas. Do not dose more than once every 24 hours.
  4. Keep carbon and the protein skimmer running. Turn off UV and mechanical filtration during treatment.
  5. Once you see results, do a 25% water change and siphon out as many flatworms as you can. Repeat the treatment as needed.

Which treatment should I use?

Salifert Flatworm eXit Blue Life Flatworm Rx
Dose 1 drop per gallon 4 drops per 10 gallons, max once per 24 hours
Carbon Remove old carbon, add fresh carbon once worms react Keep carbon running during treatment
Filtration UV and ozone off; skimmer on UV and mechanical filtration off; skimmer on
Form Ready-to-use 10 ml dropper bottle Powder you mix with RO water

Pick one and follow its own label. Don't mix the two methods in the same treatment.

Step 3: Keep them from coming back

  • Dip new corals. Flatworms usually ride in on new corals and rock. Dip new corals in a separate container before they go in the tank, using a coral dip such as Seachem Reef Dip or Tropic Marin Coral Clean Iodine Dip, at the label dose and time. See how to acclimate new fish and coral.
  • Cut extra food. Flatworm blooms often follow heavy feeding. Feed only what your fish eat.
  • Improve flow and cleaning. Clear dead spots and clean filter socks often so waste doesn't build up.
  • Watch after treatment. Eggs can hatch later, so keep an eye out and siphon any new worms early.

FAQ

Are flatworms harmful?

A few are mostly a nuisance, but large numbers can cover corals and block their light. The bigger risk is the toxin they release when many die at once, which is why prep matters.

Is Flatworm eXit reef safe?

Salifert says the product itself is quite safe for fish and invertebrates when used as directed. The danger comes from the dying flatworms, so carbon and a water change are part of the treatment.

Can I use these in freshwater?

Blue Life Flatworm Rx is for reef and fish-only saltwater tanks. Salifert Flatworm eXit is made for reef aquariums.

Shop treatments Shop carbon & filter media